[. . . ] Install two AA-type alkaline-manganese batteries with the + and - poles oriented as shown inside the battery chamber. €¢Remove batteries from the camera when not in use for a long time. - 3 - Film speed setting The camera is designed to use DX-coded ISO 100 or 400 film, and correct film speed is automatically set. [. . . ] Be sure to hold down the shutter release button halfway for a few seconds to light up the red-eye reduction lamp before pressing the button all the way to fire the flash. The red-eye reduction lamp goes out after 10 seconds automatically while holding the shutter release button halfway. Lightly press the shutter release button to lock focus on the subject. Keeping the shutter release button lightly pressed, recompose the scene. Note: To cancel focus lock, simply remove your finger from the shutter release button. When the film reaches the end of the roll, it rewinds automatically until it is fully rewound inside the film cartridge. The frame counter counts backwards until the end of the rewind, then stops automatically. Open the camera back and remove the film for processing without delay. To rewind the film in mid-roll, slide the mid-roll rewind lever in the direction of the arrow. - 9 - Specifications Type: 35mm lens shutter camera with built-in flash Film format: 24mm x 36mm (standard 35mm format) Lens: 28mm f/5. 6 lens (3 elements in 3 groups) Focusing: Active autofocus system with focus lock Shooting distance: 1m (3. ) to infinity Shutter: Mechanical lens shutter, fixed shutter speed of 1/100 sec. 85%) Frame counter: Additive type, automatic resetting to "S" when the camera back is opened. Film speed: Auto setting to ISO 100 or 400 for DX-coded film (ISO 100 for non-DX-coded film or DX-coded ISO 200 film) Film transport: Automatic advancing and rewinding, mid-roll rewind possible -10- Flash: Flash shooting distance range: Battery life: Built-in auto flash with recycling time of approx. [. . . ] During this period any one of the worldwide repair facilities listed on the reverse side will repair without charge any parts or assembly ot parts found to be defective in materials or workmanship subject to the following limitations: 1. This warranty extends to the original consumer purchaser only and is not assignable or transferable. This warranty shall not extend to any product which has been subject to misuse, abuse, negligence, accident or unauthorized repair All warranties implied by law including any warranty ot merchantability or fitness for a particular purpose shall be of a duration of one (1) year from date of purchase. [. . . ]